Intercom Paging Parameters - Avaya Octel 50 Installation Manual

Setting Up the System
Call Queuing Parameters - #85
Number of
Seconds for
First Caller in
Queue to Wait
When/How to Use
Related Parameters/Features
If Set Too High
If Set Too Low
Min

Intercom Paging Parameters

The Intercom Paging parameters define the codes the Octel 50 system dials to activate
the Intercom Paging feature. They also determine how many times and how often the
Octel 50 system pages a subscriber.
Intercom Paging Parameters - #86
Intercom Paging
Code
When/How to Use
Related Parameters/Features
If Set Too High
If Set Too Low
Min
Octel 50 Installation Guide
Max Default
1 99 1
Max Default
0 15 Blank
Configuring System Setup Parameters
This parameter specifies the number of seconds the Octel
50 system waits after attempting to transfer the first caller in
a queue to the desired extension before attempting to
transfer them again.
For most Octel 50 systems, the default setting should be
sufficient. Increase this value if you want callers to remain
on hold longer between prompt voicing.
None.
Callers may assume they have been disconnected and
hang up.
Not applicable; the default is the minimum allowed setting.
Requires
Restart Dependent
No
This parameter specifies the dialing string the Octel 50
system must send to the switch to activate Intercom Paging.
When the Octel 50 system initiates a page, it puts the caller
on hold, dials the Intercom Paging Code, then returns to the
caller.
This parameter is set when the Integrator utility is run, if
required by the switch.
The minimum and maximum for this parameter refer to the
length of the entry allowed, not an actual value.
If you want to configure zone paging, enter the zone paging
code for each mailbox in the Number field under Intercom
Paging on the Subscriber Settings dialog box. This code
overrides the Intercom Paging code.
Not applicable.
Not applicable.
Requires
Restart Dependent
No
Switch- Set by
Integrator
No No
Switch- Set by
Integrator
Yes Yes
8-45