Avaya Octel 50 Installation Manual page 125

Setting Up the System
Min
Message Waiting Light Parameters - #120
Message Waiting
Light Prefix OFF
Code
When/How to Use
Related Parameters/Features
If Set Too High
If Set Too Low
Min
Message Waiting Light Parameters - #121
Message Waiting
Light Suffix ON
Code
When/How to Use
Related Parameters/Features
If Set Too High
If Set Too Low
Octel 50 Installation Guide
Max Default
0 32 Blank
Max Default
0 32 Blank
Configuring System Setup Parameters
Requires
Restart Dependent
No
This parameter specifies the code the Octel 50 system must
insert before dialing the extension to turn the Message
Waiting Light off.
This parameter is set when the Integrator utility is run, if
required by the switch.
Some switches require both a prefix code and a suffix code.
When Integrator is run, the Octel 50 system sets both these
parameters, if required.
If Use Communications Message Waiting Light Software
(COMMMWL) is enabled, the Message Waiting Light Prefix
OFF Code must be left blank.
The minimum and maximum for this parameter refer to the
length of the entry allowed, not an actual value.
Not applicable.
Not applicable.
Requires
Restart Dependent
No
This parameter specifies the code the Octel 50 system must
insert after the extension number is dialed to turn the
Message Waiting Light on.
This parameter is set when the Integrator utility is run, if
required by the switch.
Some switches require both a prefix code and a suffix code.
When Integrator is run, the Octel 50 system sets both
parameters, if required.
If Use Communications Message Waiting Light Software
(COMMMWL) is enabled, the Message Waiting Light Suffix
ON Code must be left blank.
The minimum and maximum for this parameter refer to the
length of the entry allowed, not an actual value.
Not applicable.
Not applicable.
Switch- Set by
Integrator
Yes Yes
Switch- Set by
Integrator
Yes Yes
8-65