Table of Contents
Advertisement
Integrating with the Phone System
Running the Switch Integrator Utility
Integrator can be run from the Configuration Utility menu during installation or later from
the \CVR prompt. It is important that you run Integrator during Octel 50 system
installation, especially if you are installing the Octel 50 system for the first time.
To integrate Octel 50 with the switch:
1. During Octel 50 installation, the Configuration Utility main menu displays.
2. Select Integrator from the Configuration Utility main menu. An initial information dialog
box displays. To continue, select OK. The Select dialog box displays.
3. Use the mouse or up and down arrow keys to highlight the name of the switch, then
select Select SW. A dialog box displays the name of the selected switch. If you are
using a switch with the Simplified Message Desk Interface (SMDI), select the model
that indicates "with SMDI" or "with Voice Bridge." Be careful to select the proper
switch software version for any special board integrations.
If the switch is not listed in the Integrator, consult the switch documentation for the
correct codes.
Octel 50 Installation Guide
Running the Switch Integrator Utility
7-2
Advertisement
Table of Contents
Troubleshooting
