Pc Configuration Parameters - Avaya Octel 50 Installation Manual

Setting Up the System
Min

PC Configuration Parameters

PC Configuration Parameters - #183
Virtual Disk for
Voice File
(VDISK)
When/How to Use
Related Parameters/Features
If Set Too High
If Set Too Low
Min
PC Configuration Parameters - #184
Sound Tone on
Answer
(ANSTONE)
When/How to Use
Related Parameters/Features
If Set Too High
If Set Too Low
Min
PC Configuration Parameters - #185
Minutes Before
Blanking Screen
(DSPBLANK)
Octel 50 Installation Guide
Max Default
0 30000 1000
Max Default
– – C
Max Default
– – No
Configuring System Setup Parameters
Requires
Restart Dependent
Yes
This parameter specifies the location of the memory file
(SO3-ALL.VAP or SO3-ALL.VOX) if using a RAMdisk.
Use this parameter to specify the hard drive to be used for
RAMdisk. This parameter is only used if you chose during
installation to use RAMdisk. If this parameter is set to the
default, C, no RAMdisk is used.
None.
Not applicable.
Not applicable.
Requires
Restart Dependent
No
This parameter determines whether the Octel 50 system
sounds an audible tone when it answers an incoming call.
For most Octel 50 systems, leave this parameter disabled.
Enable this parameter when recommended by a technical
support representative for troubleshooting.
None.
Not applicable.
Not applicable.
Requires
Restart Dependent
No
This parameter specifies the number of minutes of inactivity
before the display screen blanks. The command helps
protect the phosphorous elements in the monitor screen.
Switch- Set by
Integrator
No No
Switch- Set by
Integrator
No No
Switch- Set by
Integrator
No No
8-97