Avaya Octel 50 Installation Manual page 107

Setting Up the System
When/How to Use
Related Parameters/Features
If Set Too High
If Set Too Low
Min
Intercom Paging Parameters - #90
Max. Number of
Retries in Paging
(Intercom
Redirect)
When/How to Use
Related Parameters/Features
If Set Too High
If Set Too Low
Min
Octel 50 Installation Guide
Max Default
0 9 3
Max Default
0 9 3
Configuring System Setup Parameters
For most Octel 50 systems, the default value is sufficient. If
the Octel 50 system experiences heavy traffic, increase this
value.
None.
The higher the setting, the more times the Octel 50 system
attempts to send the page.
If the Octel 50 system cannot access the busy paging
system at the first attempt, the page is not voiced.
Requires
Restart Dependent
No
This parameter specifies the number of times the Octel 50
system allows a caller to retry a page. When the caller
reaches the maximum number of retries, the Octel 50
system prompts the caller to try another extension, leave a
message, or disconnect.
When setting this parameter, consider the following:
•
If Repeat Intercom Paging Phrase is enabled, the
Octel 50 system voices the paging announcement
twice for each paging attempt before prompting the
caller to try another extension, leave a message,
retry the page, or disconnect. Note that the Octel 50
system prompts callers to try the page again only if
Max. Number of Retries in Paging (Intercom
Redirect) is set greater than 0.
•
If the subscriber's mailbox is enabled for automatic
paging, the Octel 50 system immediately pages the
subscriber when the extension is not answered,
before prompting the caller to try another extension,
leave a message, retry the page (if this parameter is
greater than 0), or disconnect.
The Paging Wait Time (Intercom Redirect) parameter
determines the amount of time the Octel 50 system waits
after paging a subscriber allowing the caller to retry the
page.
The higher the setting, the more times the intercom paging
announcement is voiced.
Does not affect Octel 50 system performance.
Requires
Restart Dependent
No
Switch- Set by
Integrator
No No
Switch- Set by
Integrator
No No
8-47