Displaying File Command Settings; Displaying The System Version Number; Repeating The Most Recent Command - Avaya Octel 50 Installation Manual

Testing and Troubleshooting the Octel 50 System
2. Select Command Line from the Display menu.
3. From the Command Line, type
Diagnostic statistics, serial call counts, and application-defined statistics are not reset with
the STRESET command.

Displaying File Command Settings

Use the following procedure to display the setting of a specified system file command.
To display a file command setting:
1. Press <ESC> to close the active display and active the menu bar.
2. Select Command Line from the Display menu.
3. From the Command Line, type
where
example, to view the value of the INBOUND setting, from the Command Line, type
SYSLOOK INBOUND

Displaying the System Version Number

Use the following procedure to display the version number of the system software.
To display the software version number:
1. Press <ESC> to close the active display and active the menu bar.
2. Select Command Line from the Display menu.
3. From the Command Line, type

Repeating the Most Recent Command

Use the following procedure to repeat the most recently entered command. This
command allows you to avoid repetitive typing when entering multiple commands.
To repeat the most recently entered command:
1. Press <ESC> to close the active display and active the menu bar.
2. Select Command Line from the Display menu.
3. From the Command Line, type
just entered the
command line, type
O 50 I G
CTEL NSTALLATION UIDE
STRESET
SYSLOOK sys_parameter
sys_parameter is the parameter whose setting you want to view. For
then press <ENTER>.
VERSION
=
STATUS command and want to display the status again, from the
then press <ENTER>.
=
Using the Command Line Interface
then press <ENTER>.
or then press <ENTER>.
VER
then press <ENTER>. For example, if you have
then press <ENTER>
13-48