Avaya Octel 50 Installation Manual page 149

Setting Up the System
If Set Too High
If Set Too Low
Min
Hangup Detection Parameters - #167
Hangup String
Timeout
(HANGUPDLY)
When/How to Use
Related Parameters/Features
If Set Too High
If Set Too Low
Min
Hangup Detection Parameters - #168
Minimum
Duration for
Drop in Loop
Current
(LCDTIME)
When/How to Use
Related Parameters/Features
If Set Too High
Octel 50 Installation Guide
Max Default
0 15 Blank
Max Default
0 30000 0
Configuring System Setup Parameters
Not applicable.
Not applicable.
Requires
Restart Dependent
No
This parameter specifies the amount of time, in 100
millisecond units, that the Octel 50 system waits between
digits before identifying a string of DTMFs as a hangup
string. This eliminates false hangup string detections.
This parameter is set when the Integrator utility is run.
Adjust this parameter only when instructed to by a technical
support representative.
This parameter must be set to a value greater than 0 if using
the Hangup String (HANGUPSTR) parameter.
DTMFs from keypresses entered by callers or subscribers
using Octel 50 system features may be incorrectly
interpreted as hangup strings.
Hangup strings may be ignored if the switch cannot send
the digits fast enough to meet this value. This may cause
excessive off hook times between calls.
Requires
Restart Dependent
No
This parameter specifies the amount of time, in 10
millisecond units, necessary to recognize a drop in loop
current, when detecting a disconnect.
This parameter is set when the Integrator utility is run.
Adjust this parameter only when instructed to by a technical
support representative.
A setting of 0 disables this parameter.
None.
If the switch sends a loop current drop for a shorter time
than the time set for LCDTIME, the Octel 50 system does
not identify the disconnect. This may cause excessive off
hook times between calls.
Switch- Set by
Integrator
Yes Yes
Switch- Set by
Integrator
Yes Yes
8-89