Table of Contents
Advertisement
3) Cut the Hole In the Mounting Surface
CAUTION:
Using the specified guide bushing and router bit (not included, see Required Accessories):
1.
Use the appropriate Installation Router Guide to mark the edges of the cutout.
2.
Carefully cut the opening in the table surface with the router.
Little clearance exists between the MXR-1001 and the hole cutout in the mounting surface. Once the MXR-1001 assembly
has been installed, the Bezel will cover the cutout hole.
Carefully align the cutout with the edges or other appropriate features in the table or mounting surface. If the cutout is
misaligned, the installed unit will be misaligned.
Use a drill and drill bit to make a starting hole within the boundary of the cutout. Use an appropriate cutting tool to finish
the cutout.
Verify that the cutting tool will not tear or chip the top surface. Ensure that the top surface of the mounting surface is not
damaged beyond the width of the trim bezel as the cutout is made.
NOTE: The process of making the cutout will create substantial dust - prepare the environment appropriately.
3.
File the four corners of the routing area square after routing.
4) Install the MXR-1001 Into the Mounting Surface
1.
Before the MXR-1001 can be installed, the Bezel must be separated from the Motor chassis: Remove the 11 screws (3 on the
front, 4 on the back, and 2 on each side), unplug the MXR cable, and lift the Bezel off of the Motor chassis (FIG. 14):
Unplug the MXR cable
from the Motor chassis
Attaching the Bezel to the Motor chassis
FIG. 12
2.
Position the Motor chassis directly beneath the cutout hole. Verify that it is oriented correctly: the plug for the MXR cable is
located on the front of the chassis (USB, Ethernet and Power connectors are on the rear).
NOTE: The Motor chassis weights approximately 18lbs (8.16Kg) - it will require a second pair of hands to keep it positioned
precisely beneath the cutout hole. Additionally, consider using the packaging material from the MXR-1001 shipping box as a
support to keep it in place during installation.
MXR-1001 - Installation & Hardware Reference Manual
Always wear safety glasses when operating the router. Failure to comply may result in eye injury.
Bezel
Mounting screws (x11)
Motor
chassis
Installing the MXR-1001
Bezel
Motor
chassis
15
Advertisement
Table of Contents
