Engine Oil/Oil Filter - KYMCO NEXXON 50 Service Manual

3
. LUBRICATION SYSTEM

ENGINE OIL/OIL FILTER

OIL LEVEL
＊
• Place the motorcycle upright on level
ground for engine oil level check.
• Run the engine for 2～3 minutes and
check the oil level after the engine is
stopped for 2～3 minutes.
Check the oil level. If the level is near the
lower limit, fill to the upper limit with the
specified engine oil.
OIL CHANGE
＊
The engine oil will drain more easily
while the engine is warm.
Remove the drain bolt to drain the engine oil
thoroughly.
Check the drain bolt washer for damage or
deformation and replace with a new one if
necessary.
ENGINE OIL FILTER
Remove the right crankcase cover attaching
bolts and right crankcase cover.
Remove the dowel pins and gasket.
Clean oil filter screen.
Specified Oil: SAE15W40
API service classification: SG
Oil Capacity: At disassembly : 1.0 liter
At change
Check for oil leaks and then start the engine
and let it idle for few minutes.
Stop the engine and recheck the oil level.
3-3
: 0.9 liter
Drain Bolt
Bolts
Oil Filter Screen Cap
NEXXON 50
Upper Limit
Lower Limit