Check/Replenish Engine Oil - KYMCO CV3 Series Manual

6
Checks before Riding

Check/Replenish Engine Oil

1. Park the vehicle on flat ground and brace up the Main
Stand. Activate KEYLESS Main Switch and start the
engine, idle it for about 3 minutes without using
Throttle Grip, then stop the engine. Allow resting for
another minute.
2. Pull out Oil Level Guide and wipe it clean, insert the
Oil Level Guide without screwing it in.
3. Check the oil level; when the oil surface nears L,
please refill the engine oil to between M and L.
 Engine and Muffler are extremely hot. Take special
care to prevent burn while checking oil level.
 After warming up the engine, stop engine and wait for
1 minute; then verify oil level with Oil Level Guide.
Recommended Oil Specification
Specification:
SAE: 10W/40 MA
API: SL Class or better
First oil change when running 1000 km; afterwards every 5000 km.
 There are many inferior oils in the market which may
cause engine failure if miss-used by the consumer.
 To ensure oil replacement of your beloved vehicle with
recommended specifications, please go to the dealer
where you purchased your vehicle from.
A slanted vehicle may lead to a faulty verification of oil

level.
If oil is checked or replaced immediately after stopping

the engine, be especially careful not to get burnt.
90
Caution
Warning
Caution
3