Driven Pulley Face Bearing Replacement - KYMCO GRAND DINK 50 Service Manual

8
. KICK STARTER/DRIVE PULLEY/
CLUTCH/DRIVEN PULLEY
DRIVEN PULLEY FACE BEARING
REPLACEMENT
Check the needle bearings in the driven
face and replace them if they have
excessive play, damage or abnormal noise.
Drive the inner bearing out of the driven
pulley face.
Remove the snap ring and drive the outer
bearing out of the driven face.
Drive a new outer bearing into the driven
face with the sealed end facing up.
Seat the snap ring in its groove.
Pack all bearing cavities with 5.0
5.6g grease.
Specified grease:230 Heat-
8-15
resistant grease
GRAND DINK 50
Inner Bearing
Snap Ring
Outer Bearing
Bearing Outer Driver, 37x40mm