Grounding The Switch - H3C S12508-AC Installation Manual

Grounding the switch

WARNING!
For the safety of operators and equipment, securely ground the switch. Make sure that the resistance
reading between the switch chassis and the ground is less than 1 ohm.
Most racks are equipped with a grounding strip. You can connect the yellow-green grounding cable of
the switch to the grounding strip.
NOTE:
Use the supplied grounding cable (CAT 6 cable with dual-hole OT terminals).
To connect the grounding cable:
Remove the two grounding screws from the switch chassis.
1.
Use the grounding screws to attach one end of the grounding cable to the chassis.
2.
Connect the other end of the grounding cable to the grounding strip of the rack in the same way.
3.
Figure 29 Connect the grounding cable
1
2
3
34