Rebooting Your Switch - H3C S12508-AC Installation Manual

H3c s12500 routing switch series installation guide
Hide thumbs Also See for S12508-AC:
Table of Contents

Advertisement

1/11
1/12
1/13
1/14
1/15
1/16
1/17
1/18
Table 17 display device command output description
Field
Slot No.
Brd Type
Brd Status
Subslot Num
Sft Ver

Rebooting your switch

When a fault occurs to a running switch, you can remove the fault by rebooting the switch.
To reboot a switch, use one of the following methods:
Power on the switch after powering it off, which is also called hard reboot or cold start. Powering off
a running switch causes data loss and hardware damages, and therefore this method is not
recommended.
Trigger an immediate reboot at the command line interface (CLI).
Enable the scheduled reboot function at the CLI. You can set a time at which the switch can
automatically reboot, or set a delay so that the switch can automatically reboot within the delay.
NONE
Absent
NONE
Absent
NONE
Absent
NONE
Absent
LST1SF08B1
Normal
NONE
Absent
NONE
Absent
NONE
Absent
Description
Slot number of a card (standalone mode); slot number of a card on the specified
member switch in the format of member ID/slot number (IRF mode)
Hardware type of a card, which can be:
Specific card model, such as LST1MRPNC1, which is the same as the silkscreen.
NONE: No card is in the slot.
UNKNOWN: The card is not supported by the software version and thus cannot
start normally.
Card status, which can be:
Absent: No card is in the slot.
Master: The card is an active main board (AMB).
Slave: The card is a standby main board (SMB).
Normal: The card is an interface card and operates normally.
Fault: The card in the slot has not started or fails.
Off: The card is not powered on.
Illegal: The card is not supported by the software version and thus cannot start
normally.
Number of subcards
Software version of the current card, which can be:
Specific software version: The software version of the switch.
NONE: No card is in the slot.
Mismatched: The software version does not support the card and thus cannot be
uploaded.
0
NONE
0
NONE
0
NONE
0
NONE
0
S12500-CMW520-A1221
0
NONE
0
NONE
0
NONE
59

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

S12518-dcS12508-dcS12518-ac

Table of Contents