Installation Tools - H3C S12508-AC Installation Manual

The slide rails (or rack shelves) can support the weight of the switch chassis and its accessories.
•
• The rack can be well grounded.
The rack has good ventilation system, and the porosity of the front and back doors is greater than
•
50%.

Installation tools

Accessories supplied by the switch
Item
Console cable
Grounding cable
Mounting brackets
M4*8 screw
M6*12 screw
M6 cage nut
Air deflector
ESD-preventive wrist strap
NOTE:
The number of screws and nuts supplied with the switch depends on those shipped from the factory.
User-supplied tools and equipment
• Mechanical lift
Phillips screwdriver P1 – 100 mm, P2 – 150 mm and P3 – 250 mm
•
• Flat screwdriver P4 – 75 mm
Marker
•
Tape
•
• Diagonal pliers, wire-stripping pliers, and wire clippers
Socket wrench
•
Cables such as network cables and fiber cables
•
Meters and equipment, such as hub and multimeter
•
Configuration terminal, such as PC
•
NOTE:
The rack accessories and installation tools are not included in this section. The accessories and installation
tools may vary depending on the rack model. For more information, see the installation guide of the
corresponding rack.
Quantity
1
1
1 pair
1 set
1 set
1 set
1
2
23
Purpose
Connecting the console port and
the configuration terminal for
switch login
Grounding the switch
Fixing the switch to the rack
Fixing the mounting brackets to the
switch
Fixing the switch to the rack
Installed at the rear of the switch to
block air from entering the chassis
(optional)
ESD-prevention