H3C S12508-AC Installation Manual page 65

Connect an SFP+ cable (optional)
When connecting SFP+ ports located near each other, besides SFP+ transceiver module and optical
fiber, you can use an SFP+ cable.
Figure 49 SFP+ cable
(1) Connector
To connect an SFP+ cable:
Wear an ESD-preventive wrist strap and make sure the strap has a good skin contact and is well
1.
grounded.
Unpack the SFP+ cable.
2.
Insert one end of the plug of the SFP+ cable horizontally into the SFP+ slot on the switch and the
3.
other end of the plug into the SFP+ slot of the peer device.
NOTE:
SFP+ cables are hot swappable.
•
When connecting an SFP+ cable, make sure that the bend radius of the cable is no less than eight times
•
of the diameter of the cable.
Installing fiber management tray (optional)
NOTE:
The installation method described below is based on an N68 cabinet. The installation procedure is only
for your reference if you use a non-N68 cabinet.
A fiber management tray (FMT) is installed in a cabinet for winding redundant fibers between the
S12500 and other devices.
Preparations
Confirm the following prerequisites:
The cabinet is fixed.
•
The switch is installed.
•
The installation involves the following materials:
FMT
•
M5×10 self-tapping screws (two screws for one FMT)
•
Installation procedure
To install the fiber management tray:
(2) Pull latch
55