H3C S12508-AC Installation Manual page 90

Field
Temp high
Temp low
Voltage high
Voltage low
Transceiver info I/O error
Transceiver info checksum
error
Transceiver type and port
configuration mismatch
Transceiver type not
supported by port hardware
XFP
RX loss of signal
RX not ready
RX CDR loss of lock
TX fault
TX not ready
TX CDR loss of lock
Module not ready
APD supply fault
TEC fault
Wavelength unlocked
RX power high
RX power low
TX power high
TX power low
TX bias high
TX bias low
Temp high
Temp low
Voltage high
Voltage low
Transceiver info I/O error
Transceiver info checksum
error
Transceiver type and port
configuration mismatch
Remarks
Temperature is high.
Temperature is low.
Voltage is high.
Voltage is low.
Transceiver information read and write error
Transceiver information checksum error
Transceiver type does not match port configuration.
Transceiver type is not supported on the port.
RX signal is lost.
RX is not ready
RX clock cannot be recovered.
TX fault
TX is not ready
TX clock cannot be recovered.
Module is not ready.
Avalanche Photo Diode (APD) supply fault
Thermoelectric Cooler (TEC) fault
Wavelength of optical signal exceeds the manufacturer's tolerance.
RX power is high.
RX power is low.
TX power is high.
TX power is low.
TX bias current is high.
TX bias current is low.
Temperature is high.
Temperature is low.
Voltage is high.
Voltage is low.
Transceiver information read and write error
Transceiver information checksum error
Transceiver type does not match port configuration.
80