Figure 79 Label for power cords
12.2
0.6
(1)
(1) Cable tie
Printing labels
The contents can be printed or written on the labels.
Template for printing
The Word template is available from H3C for printing labels.
When using the template, you can directly modify the contents; note the following rules:
•
The settings of centered characters, direction, and fonts should not be changed.
When there are too many characters to be filled in, zoom out the characters, but make sure the
•
printouts are clear and legible.
Cells merging on the template
To merge the cells, first recover the table structure (if gridlines are displayed, you can start from Step 3
directly):
Select Edit > Select All from the toolbar.
1.
Select Format > Borders and Shading > Borders. Select Box and click OK.
2.
Drag the mouse to select the cells to be merged and select Table > Merge Cells.
3.
If two merged cells are still not enough to accommodate the characters, use multiple lines.
4.
Requirements on the printer
To print the labels, use a laser jet printer. Before printing the label, set up the page and try the printing
on ordinary blank paper (both sides are blank):
Cover the blank paper onto the whole page of label paper, and check whether the page setup
1.
conforms to the requirement.
Make sure the printer properties, such as "paper size" and "direction", have been set correctly.
2.
If the warning prompt as shown in
3.
printing.
10
26.2
TO:
11
(2)
100
(3)
R1.0
25
1.5
0.6
(2) Label
Figure 80
appears before printing, click Ignore to continue the
141
(3) Dividing line on the label