H3C S12508-AC Installation Manual page 91

Field
Transceiver type not
supported by port hardware
# Display the currently measured values of the fault detection parameters of the H3C-customized
transceiver plugged in interface GigabitEthernet 3/0/1.
<Sysname> display transceiver diagnosis interface Gigabitethernet 3/0/1
GigabitEthernet3/0/1 transceiver diagnostic information:
Current diagnostic parameters:
Temp(°C) Voltage(V)
36 3.31
Table 26 display transceiver diagnosis command output description
Field
transceiver diagnostic information
Current diagnostic parameters
Temp.(°C)
Voltage(V)
Bias(mA)
RX power(dBM)
TX power(dBM)
Remarks
Transceiver type is not supported on the port.
Bias(mA) RX power(dBM)
6.13 -35.64
Description
Fault detection information of the transceiver plugged in the
interface
Current fault detection parameters
Fault detection parameter-temperature, in °C, with the precision to
1°C.
Fault detection parameter-voltage, in V, with the precision to 0.01 V.
Fault detection parameter-bias current, in mA, with the precision to
0.01 mA.
Fault detection parameter-RX power, in dBM, with the precision to
0.01 dBM.
Fault detection parameter-TX power, in dBM, with the precision to
0.01 dBM.
81
TX power(dBM)
-5.19