H3C S12508-AC Installation Manual page 154

Figure 83 Fold up the label
Cable
After the printed part of the label has been folded up, the narrow part of the label should be
3.
covered completely, as shown in
Figure 84 Appearance of affixed labels on signal cables
Cable
TO:
A03 33 33 33 33
Affixing the label to the power cord
Remove the label from the bottom page and affix it to the identification plate on the cable tie. The label
should be stuck to the rectangular flute, and should be stuck to only one side of the identification plate.
Make sure to affix the labels on the same side of the identification plates. The cable ties are bundled at
2 cm (0.79 in) from the connectors, and other positions are allowed in special circumstances.
Cable ties should be bundled on both ends of a cable. After the bundling, the finished identification
plate should be on top of the cable in horizontal cabling, or on the right side of the cable in vertical
cabling. Make sure the label is facing out, as shown in
Stick side
Fold up
Cable
Stick side
Fold to right
Figure 84.
Cable
Figure
144
85.