H3C S12508-AC Installation Manual page 150

Figure 78 Label for signal cables
7.5
11.0
11.0
(1)
(1) Dividing line
The dividing lines on the label help to specify more clearly the position of a cable. For example, there is
one between the cabinet number and the frame number and another one between the frame number
and the slot number. The dividing line is 1.5 × 0.6 mm (0.06 × 0.02 in) in size with the color of
PONTONE 656c (light blue).
The cut dotted line helps to fold the label when you affix it to the cable, and its size is 1.0 × 2.0 mm (0.04
× 0.08 in).
There is a mark "TO:" (upside down in the figure) at the lower right corner of the label. The mark is used
to identify the opposite end of the cable on which the label is affixed.
Label for power cords
The label for power cords should be attached to the identification plate on the cable ties that are bundled
to the cable. The identification plate has an embossment of 0.2 × 0.6 mm (0.008 × 0.02 in) around
(symmetric on both sides), and the area in the middle is for affixing the label, as shown in
(expressed in mm):
84.0
7.0
5.5
5.5
(2)
5.5
5.5
7.0
7.5
37.0
10.0
1.5
(2)
0.6
1.0
(1)
2.0
(2) Cut dotted line
140
Figure 79