Information Carried On Labels - H3C S12508-AC Installation Manual

Figure 85 Appearance of affixed labels on power cords
Cable

Information carried on labels

For power cords
Labels for power cords are only affixed on one side of the identification plates. On the labels, there is
information (the part after the mark "TO:") about the location of the device on the other end of the cable,
like the location of control cabinet, distribution box, or power socket.
For signal cables
The two sides of the label affixed on the signal cable carry information about the location of the ports
connected to both ends of the cable, as shown in
The following information is included:
Area 1 contains the location information of local end of the cable.
•
Area 2 (with the mark "TO:") contains the location information of the opposite end of the cable.
•
Area 3 has been folded up inside the label.
•
Figure 86 Printed parts on the label for signal cables
The text part of the label is on the right side of the cable. The side with "TO:" that is facing outside carries
the location information of the opposite end; and the other side carries the location information of the
local end. The information in Area 1 at one end is the same as the information in Area 2 at the other end
of the cable, and vice versa. In other words, the local information at one end is called the opposite
information at the other end.
Cable
Area 1
TO:
B03 -48V2
Figure 86.
Area 3
145