Replacing A Pem (Applicable To Only An Ac Power Module) - H3C S12508-AC Installation Manual

Figure 60 Replace a power module
A

Replacing a PEM (applicable to only an AC power module)

To replace a PEM:
Use a Philips screwdriver to loosen the screws on the front panel of the PEM.
1.
Slowly pull the PEM out along the slide rails, as shown in
2.
Put the removed PEM on an antistatic mat or in its original shipping materials.
3.
Unpack a new PEM, and slowly insert the PEM along the slide rails until the PEM has close contact
4.
with the power frame backplane, as shown in
Use a Phillips screwdriver to fasten the screws on the PEM panel.
5.
3
1
2
B
4
6
Figure
Figure 62.
93
5
61.