Enable Wan Qos And Select The Wan Qos Type - NETGEAR ProSafe FVS336Gv2 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
Setting
Hosts
Start IP
End IP
Select Group
Bandwidth Allocation
Outbound Minimum
Bandwidth
Outbound Maximum
Bandwidth
Inbound Minimum
Bandwidth
Inbound Maximum
Bandwidth
Diffserv QoS Remark
9. Click the Apply button.
Your settings are saved. The profile is added to the List of QoS Profiles table on the QoS
screen.
You are now ready to enable WAN QoS and select the priority QoS type (see
WAN QoS and Select the WAN QoS Type

Enable WAN QoS and Select the WAN QoS Type

Depending on the type of WAN QoS that you want to select, first configure one or more rate
control QoS profiles (see
QoS profiles (see Add a Priority Queue WAN QoS Profile
WAN QoS and select the type of WAN QoS.
Note: When you enable WAN QoS, the performance of the VPN firewall
might be affected slightly.

To enable WAN QoS and select the type of WAN QoS:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
Description
These settings do not apply to a priority profile.
Enter a DSCP value in the range of 0 through 63. Packets are marked with this
value. Leave this field blank to disable packet marking.
Add a Rate Control WAN QoS Profile
Configure the IPv4 Internet and WAN Settings
80
on page 80).
on page 75) or priority control
on page 78) before you enable
Enable