NETGEAR ProSafe FVS336Gv2 Reference Manual page 203

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
9. Enter the settings as described in the following table.
Setting
Start IPv6 Address
End IPv6 Address
Prefix Length
10. Click the Apply button.
Your settings are saved. The new IPv6 address pool is added to the List of IPv6 Address
Pools table on the DMZ Setup (IPv6) screen.
Change an IPv6 DMZ Address Pool
The following procedure describes how to change an existing IPv6 DMZ address pool.

To change an IPv6 DMZ address pool:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
For the default administrative account, the default user name is admin and the default
password is password.
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
Description
Enter the start IP address. This address specifies the first of the contiguous
addresses in the IP address pool. Any new DHCPv6 client joining the DMZ is
assigned an IP address between this address and the end IP address.
Enter the end IP address. This address specifies the last of the contiguous
addresses in the IP address pool. Any new DHCPv6 client joining the DMZ is
assigned an IP address between the start IP address and this IP address.
Enter the IPv6 prefix length, for example, 10 or 64.
Configure the IPv6 LAN Settings
202