NETGEAR ProSafe FVS336Gv2 Reference Manual page 111

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
For the default administrative account, the default user name is admin and the default
password is password.
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select Network Configuration > WAN Settings > WAN Mode.
The WAN Mode screen displays.
Note: The IPv6 radio button is disabled. However, you can configure
auto-rollover mode for IPv6 interfaces with the IPv4 radio button selected.
7. In the Load Balancing Settings section, configure the following settings:
a. Select the Primary WAN Mode radio button.
b. From the corresponding menu on the right, select a WAN interface to function as the
primary WAN interface.
Configure the IPv6 Internet and WAN Settings
111