Manually Configure A Static Ipv6 Internet Connection - NETGEAR ProSafe FVS336Gv2 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
• Prefix delegation check box is selected. A prefix is assigned by the ISP DHCPv6
server through prefix delegation, for example, 2001:db8:: /64.
The VPN firewall's own stateless DHCPv6 server can assign this prefix to its IPv6
LAN clients. For more information about prefix delegation through the stateless
DHCPv6 server in the LAN, see
Delegation for the LAN
• Prefix delegation check box is cleared. Prefix delegation is disabled. This is the
default setting.
12. Click the Apply button.
Your settings are saved.
13. Verify the connection:
a. Select Network Configuration > WAN Settings > WAN Setup.
The WAN Setup screen displays the IPv4 settings.
b. In the upper right, select the IPv6 radio button.
The WAN Setup screen displays the IPv6 settings (see the figure that is shown in
Step 7).
c. In the IPv6 WAN Settings table, click the Status button for the WAN interface for
which you want to display the connection status.
The Connection Status pop-up screen displays. The following figure shows a dynamic
IP address configuration.
The Connection Status screen shows a valid IP address and gateway. You are
connected to the Internet. For more information about the connection status, see
View the WAN Port Status and Terminate or Establish the Internet Connection
page 594.
If the configuration was not successful, try to manually configure the connection. For
more information, see the following sections:
•

Manually Configure a Static IPv6 Internet Connection

• Manually Configure a PPPoE IPv6 Internet Connection
Manage a Stateless DHCPv6 Server with Prefix
on page 158.
Configure the IPv6 Internet and WAN Settings
93
on page 94
on page 97
on