Set The Wan Connection Type And Corresponding Speeds - NETGEAR ProSafe FVS336Gv2 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
Your settings are saved.

Set the WAN Connection Type and Corresponding Speeds

The WAN connection type and corresponding upload and download connection speeds in
effect limit the rate of traffic that is being forwarded by the VPN firewall.

To set the WAN connection type and upload and download connection speeds:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
For the default administrative account, the default user name is admin and the default
password is password.
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select Network Configuration > WAN Settings > WAN Setup.
The WAN Setup screen displays the IPv4 settings.
7. In the WAN IPv4 Settings table, click the Edit button for the WAN interface that you want to
configure.
The WAN IPv4 ISP Settings screen displays.
8. Click the Advanced option arrow in the upper right.
The WAN Advanced Options screen displays for the WAN interface that you selected.
The following figure shows the WAN2 Advanced Options screen as an example.
Configure the IPv4 Internet and WAN Settings
72