View The Vpn Firewall Ssl Vpn Log - NETGEAR ProSafe FVS336Gv2 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
The SSL VPN Connection Status table lists each active connection with the information
that is described in the following table.
Item
Username
Group
IP address
Login Time
Action
7. To disable an active SSL user, in the SSL VPN Connection Status table, click the
corresponding Disconnect button.
The user is disconnected.
8. To disable another active L2TP user, repeat

View the VPN Firewall SSL VPN Log

The SSL VPN log on the VPN firewall displays notifications and, if errors occur, error
messages that are detected on the VPN firewall side. If problems occur during the SSL portal
establishment process, these error messages can help you to determine what the problem is.
(Misconfigration is the most common problem.)

To display the SSL VPN log on the VPN firewall:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
For the default administrative account, the default user name is admin and the default
password is password.
Description
The user name that is associated with the SSL session.
The group to which the user is assigned.
The IP address from the user is logged in.
The time that the user logged in.
The Disconnect button lets you terminate the SSL VPN tunnel connection.
(This button displays only if an active SSL connection exists.)
Set Up Virtual Private Networking with SSL Connections
Step 7.
445