Configure Load Balancing Or Auto-Rollover For Ipv4 Interfaces; Load Balancing And Auto-Rollover For Ipv4 Wan Interfaces - NETGEAR ProSafe FVS336Gv2 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
The Connection Status pop-up screen displays. The IP addresses that are shown in
this figure are not related to any other examples in this manual.
The Connection Status screen shows a valid IP address and gateway. You are
connected to the Internet.
Note: If the configuration was not successful, see
Connection
Configure Load Balancing or Auto-Rollover for IPv4
Interfaces
You can configure the VPN firewall's IPv4 interfaces on a mutually exclusive basis for either
auto-rollover (for increased system reliability) or load balancing (for maximum bandwidth
efficiency). If you do not select load balancing, you must specify one WAN interface as the
primary interface.
The following sections provide information about configuring load balancing and auto-rollover
for IPv4 interfaces:
•

Load Balancing and Auto-Rollover for IPv4 WAN Interfaces

• Configure Load Balancing Mode and Optional Protocol Binding for IPv4 Interfaces
• Configure the Auto-Rollover Mode and Failure Detection Method for IPv4 Interfaces
Load Balancing and Auto-Rollover for IPv4 WAN Interfaces
The VPN firewall supports the following modes for IPv4 interfaces:
• Load balancing mode. The VPN firewall distributes the outbound traffic equally among
the WAN interfaces that are functional. You can configure two WAN interfaces. The VPN
on page 615.
Configure the IPv4 Internet and WAN Settings
48
Troubleshoot the ISP