NETGEAR ProSafe FVS336Gv2 Reference Manual page 451

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
Create a Portal Layout
The portal layout specifies the login screen that you present to an SSL VPN user and
determines the type of access that you grant.

To create a portal layout:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
For the default administrative account, the default user name is admin and the default
password is password.
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select VPN > SSL VPN > Portal Layouts.
The Portal Layouts screen displays the IPv4 settings. The following figure shows the
default IPv4 SSL portal (SSL-VPN) and a custom portal.
Note: If you have enabled IPv6 (see
page 88), when you create a portal with an IPv4 address, the same
portal is automatically created with an IPv6 address.
The List of Layouts table displays the following fields:
• Layout Name. The descriptive name of the portal.
Manage the IPv6 Routing Mode
Set Up Virtual Private Networking with SSL Connections
449
on