Add Dmz Wan Rules; Add Dmz Wan Outbound Service Rules - NETGEAR ProSafe FVS336Gv2 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
Menus that apply to all IPv6 LAN WAN inbound
rules
LAN Users
WAN Users
Log
10. Click the Apply button.
Your settings are saved. The new rule is added to the Inbound Services table on the LAN
WAN Rules screen.

Add DMZ WAN Rules

The following sections provide information about managing DMZ WAN rules:
•

Add DMZ WAN Outbound Service Rules

• Add LAN WAN Inbound Service Rules
Add DMZ WAN Outbound Service Rules
For DMZ WAN traffic, the default outbound policy is to block all traffic to the Internet.
You can change the default policy by adding DMZ WAN firewall rules that allow specific types
of traffic to go out from the DMZ to the Internet. Alternately, you can allow all outbound traffic
and then block only specific services from passing through the VPN firewall.
You can allow or block access based on the service or application, source or destination IP
addresses, and time of day.
The following sections provide information about adding DMZ WAN outbound service rules:
• Add an IPv4 DMZ WAN Outbound Rule
• Add an IPv6 DMZ WAN Outbound Rule
Add an IPv4 DMZ WAN Outbound Rule
The following procedure describes how to add an IPv4 DMZ WAN outbound rule.

To add an IPv4 DMZ WAN outbound rule:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
Menus that apply only when your selection from
the Action menu is not BLOCK always
Customize Firewall Protection
233