NETGEAR ProSafe FVS336Gv2 Reference Manual page 464

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
Your settings are saved. VPN tunnel clients are now able to connect to the VPN firewall
and receive a virtual IPv4 address in the client address range.
Add an IPv4 Route for VPN Tunnel Clients
If the assigned client IPv4 address range is in a different subnet from the local network, or if
the local network has multiple subnets, or if you select split-tunnel operation, you must define
client routes.

To add an IPv4 route for SSL VPN tunnel clients:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
For the default administrative account, the default user name is admin and the default
password is password.
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select VPN > SSL VPN > SSL VPN Client.
The SSL VPN Client screen displays the IPv4 settings. The following figure shows an
example.
Set Up Virtual Private Networking with SSL Connections
462