Manage Static Ipv6 Routing; Add A Static Ipv6 Route - NETGEAR ProSafe FVS336Gv2 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
7. In the upper right, select the IPv6 radio button.
The DMZ Setup screen displays the IPv6 settings.
8. In List of IPv6 Address Pools table, select the check box to the left of each address pool
that you want to remove or click the Select All button to select all address pools.
9. Click the Delete button.
The selected IPv6 address pools are removed from the List of IPv6 Address Pools table.

Manage Static IPv6 Routing

The following sections provide information about managing static IPv6 routing:
•

Add a Static IPv6 Route

• Change a Static IPv6 Route
• Remove One or More Static IPv6 Routes
Note: NETGEAR's implementation of IPv6 does not support RIP next
generation (RIPng) to exchange routing information, and dynamic
changes to IPv6 routes are not possible. To enable routers to
exchange information over a static IPv6 route, you must manually
configure the static route information on each router.
Add a Static IPv6 Route
The following procedure describes how to add an IPv6 static route to the VPN firewall.

To add a static IPv6 route to the VPN firewall:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
For the default administrative account, the default user name is admin and the default
password is password.
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
Configure the IPv6 LAN Settings
204