Back Panel - NETGEAR ProSafe FVS336Gv2 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
Table 1. LED descriptions (continued)
LED Activity
WAN Ports
Left LED Green
Blinking green
Off
Right LED Green
Amber
Off
Internet LED Green
Amber
Off

Back Panel

The back panel of the VPN firewall includes a console port, a cable security lock receptacle,
a recessed Factory Defaults reset button, and an AC power connection.
Console port
Figure 2. Back panel
Viewed from left to right, the back panel contains the following components:
• Console port. Port for connecting to an optional console terminal. The port has a DB9
male connector. The default baud rate is 115200 K. The pinouts are (2) Tx, (3) Rx, (5) and
(7) Gnd. For information about accessing the command-line interface (CLI) using the
console port, see Use the Command-Line Interface
• Cable security lock receptacle.
Get an Overview of the Features and Hardware and Log In
Description
The WAN port has a valid connection with a device that provides an
Internet connection.
The WAN port receives or transmits data.
The WAN port has no physical link, that is, no Ethernet cable is plugged
into the VPN firewall.
The WAN port operates at 1000 Mbps.
The WAN port operates at 100 Mbps.
The WAN port operates at 10 Mbps.
The WAN port has a valid Internet connection.
The Internet link is down because the WAN port is in standby mode for
failover. Also, before the connection is up, there is an amber color for a
short period of time.
The WAN port is either not enabled or has no link to the Internet.
Factory Defaults
reset button
Cable security
lock receptcle
20
AC power
receptacle
on page 537.