Setting The Registration-Mark Mode - GRAPHTEC CE3000-40 User Manual

5
Step
Press the (PAUSE) key to cancel PAUSE mode.
CHECKPOINT
The registration-mark conditions that can be read by the cutting plotter are as fol-
lows.
• Registration-mark line width: 0.3 mm to 1.0 mm (The registration-mark center
• Registration-mark size: 5 mm to 20 mm (See "Setting the Registration-mark
• Registration-mark pattern: Pattern 1 or 2
• Registration marks must be formed of single lines.
• Registration marks must be drawn in black.
Setting the Registration-mark Size
This sets the size of the registration marks to be read.
1
Step
Press the (PAUSE) key to switch to PAUSE mode.
2
Step
Press the (NEXT) or
A U T O R E G . M A R K
3
Step
Press the (ENTER) key to display the Auto Reg. Mark submenu, and then press the
(PREV.) key until the following menu is displayed.
M A R K S I Z E
4
Step
Press the (ENTER) key to display the registration-mark size setting.
M A R K S I Z E 1 0 m m
lines are used as the data.)
Size.")
(PREV.) key until the following menu is displayed.
4 – 13
X
Y
(NEXT) or