An Error Message Was Displayed - GRAPHTEC CE3000-40 User Manual

Symptom
The medium is cut, but it is dif-
ficult to weed afterward.
The cut medium cannot be
picked up using a retack
sheet.
Characters and lines are
deformed when plotted using
the pen.
6.4

An Error Message Was Displayed

Symptom
CURRENT LIMIT or POSI-
TION ERROR is displayed.
The POWER lamp flickers.
SPEED ERROR is displayed.
The POWER lamp flickers.
If any of the following command error messages appear, they are nearly always caused by one of the fol-
lowing two reasons:
• The software or host-computer settings have been changed.
• The cutting-plotter interface settings have been changed.
Solutions
• Configure the settings in the software menu so that the menu can control the cutting plotter.
• Set the host-computer interface conditions correctly.
• Set the cutting-plotter interface conditions correctly.
Cause
The retack sheet is not sufficiently
adhesive.
The medium becomes entangled
after cutting.
Weeding of the cut medium was
left too long.
A blade has been selected in the
cutter-pen settings.
Cause
The cutting conditions are not suitable for the
medium being cut.
Excessive load is causing the current to the
motor to exceed the rated value.
The pen carriage movement is being obstructed.
The pen carriage was subjected to external pres-
sure during cutting.
Scraps of the medium in the moving parts are
impeding operation.
If this problem occurs frequently, contact your sales representative or nearest
Graphtec dealer.
The pen carriage was subjected to external pres-
sure after the power was turned on.
The internal speed control is faulty.
If this problem occurs frequently, contact your sales representative or nearest
Graphtec dealer.
6 – 4
Solution
Use a retack sheet with greater adhesion.
Adjust the blade extension length.
Reduce the cutting force.
Weed the cut medium promptly.
Select PEN.
Solution
Reduce the cutting speed.
Reduce the cutting force.
Remove the obstruction and
turn the cutting plotter back
on.
Turn the cutting plotter off
and then back on again.