Grandstream Networks UCM6510 IP PBX User Manual page 95

Advanced Settings
Switch Type
Coding
CRC
PRI Dial Plan
PRI Local Dial Plan
International Prefix
National Prefix
Local Prefix
Private Prefix
Unknown Prefix
PRI Indication
Reset Interval
PRI Exclusive
Firmware Version 1.0.0.25
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Otherwise, the caller will listen to the tone from peer device. The default
setting is disabled.
Select switch type.

EuroISDN: EuroISDN (common in Europe)

NI2: National ISDN type 2 (common in the US)

DMS100: Nortel DMS100

4ESS: AT&T 4ESS

5ESS: Lucent 5ESS

NI1: old national ISDN type 1

Q.SIG
Select "HDB3" or "AMI".
Select whether to use CRC4 or not.
This setting is used to specify the type of the callee number. The service
provider will usually verify this. The default setting is "unknown". In some
very unusual circumstances, you may need set to "Dynamic" or
"Redundant".
Note:
When one type is selected, you might not be able to dial another class of
numbers. For example, if "National" is configured, you won't be able to
dial local or international numbers.
This setting is used to specify the type of the caller number. The service
provider will usually verify this.
Configure the prefix in PRI Local Dial Plan and PRI Dial Plan for each
type.
Select the PRI Indication.

outofband: Use RELEASE, DISCONNECT or other messages with
CAUSE to indicate call progress (e.g., cause: unassigned number or
user busy).

inband: use in-band tones to play busy or congestion signal to the
other side. This is the default setting.
The interval that restarts idle channels.
This setting is used to set up the ChannelID in SETUP message. If
enabled, only the specified B channel can be used. Otherwise, select one
of the channels in B channel. If you need override the existing channels
UCM6510 IP PBX User Manual Page 93 of 229