Manual Provisioning; Discovery; Figure 28: Auto Discover - Grandstream Networks UCM6510 IP PBX User Manual

Pick Extension Period (hour):
Please make sure an extension is manually assigned to the phone or "Automatically Assign Extension" is
enabled during provisioning. After the configuration on the UCM6510 web GUI, click on "Save" and "Apply
Changes". Once the phone boots up and picks up the config file from the UCM6510, it will take the
configuration right away.

MANUAL PROVISIONING

DISCOVERY

Users could manually discover the device by specifying the IP address or scanning the entire LAN
network. Three methods are supported to scan the devices.

PING

ARP

SIP Message (NOTIFY)
Click on "Auto Discover", fill in the "Scan Method" and "Scan IP". The IP address segment will be
automatically filled in based on the network mask detected on the UCM6510. If users need scan the
entire network segment, enter 255 (for example, 192.168.40.255) instead of a specific IP address. Then
click on "Save" to start discovering the devices within the same network. To successfully discover the
devices, "Zero Config" needs to be enabled on the UCM6510 web GUI->PBX->Basic/Call Routes->Zero
Config->Auto Provisioning Settings.
The following figure shows a list of discovered phones. The MAC address, IP Address, Extension (if
assigned), Version, Vendor, Model, Connection Status, Create Config, Options (Edit/Delete/Update) are
displayed in the list.
Firmware Version 1.0.0.25
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
>General page->Extension Preference section: "Pick Extensions".
Specify the number of minutes to allow the phones being provisioned to
pick extensions.

Figure 28: Auto Discover

UCM6510 IP PBX User Manual Page 60 of 229