Grandstream Networks UCM6510 IP PBX User Manual page 172

Audio Mix Record
DND/Call Forward
Do Not Disturb (DND) Activate
Do Not Disturb (DND) Deactivate
Call Forward Busy Activate
Call Forward Busy Deactivate
Call Forward No Answer Activate
Call Forward No Answer
Deactivate
Call Forward Unconditional
Activate
Call Forward Unconditional
Deactivate
Feature Misc
Feature Code Digits Timeout
Call Park
Firmware Version 1.0.0.25
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299

Options
Disable
Allow Caller: Enable the feature code on caller side only.
Allow Callee: Enable the feature code on callee side only.
Allow Both: Enable the feature code on both caller and callee.

Default code: *3.

Enter the code followed by # or SEND to start recording the
audio call and the UCM6510 will mix the streams natively on
the fly as the call is in progress.

Options
Disable
Allow Caller: Enable the feature code on caller side only.
Allow Callee: Enable the feature code on callee side only.
Allow Both: Enable the feature code on both caller and callee.

Default code: *77.

Default code: *78.

Default Code: *90.

Enter the code and follow the voice prompt. Or enter the code
followed by the extension to forward the call.

Default Code: *91.

Default Code: *92.

Enter the code and follow the voice prompt. Or enter the code
followed by the extension to forward the call.

Default Code: *93.

Default Code: *72.

Enter the code and follow the voice prompt. Or enter the code
followed by the extension to forward the call.

Default Code: *73.

Default Setting: 1000.

Configure the maximum interval (in milliseconds) between the
digits input to activate the feature code.

Default Extension: 700.

During an active call, initiate blind transfer and then enter this
code to park the call.
UCM6510 IP PBX User Manual Page 170 of 229