Digital Trunk Configuration; Table 31: Digital Trunk Configuration Parameters - Grandstream Networks UCM6510 IP PBX User Manual

Private Prefix
Unknown Prefix

DIGITAL TRUNK CONFIGURATION

After configuring digital hardware, go to web GUI->PBX->Basic/Call Routes->Digital Trunks.

Click on "Create New Digital Trunk" to add a new digital trunk.

Click on to configure detailed parameters for the digital trunk.

Click on to configure Direct Outward Dialing (DOD) for the digital Trunk.

Click on to delete the digital trunk.
The digital trunk parameters are listed in the table below.
Trunk Name
Channel Group
Hide CallerID
Keep Trunk CID
Caller ID
CallerID Name
Firmware Version 1.0.0.25
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299

Table 31: Digital Trunk Configuration Parameters

Configure trunk name to identify the digital trunk.
Configure the digital channel group used by the trunk.
Configure to hide outgoing caller ID. The default setting is "No".
If enabled, the trunk CID will not be overridden by extension's CID when
the extension has CID configured. The default setting is "No".
Configure the Caller ID. This is the number that the trunk will try to use
when making outbound calls. For some providers, it might not be possible
to set the CallerID with this option and this option will be ignored.
When making outgoing calls, the following rules are used to determine
which CallerID will be used if they exist:

The CallerID configured for the extension will be looked up first.

If "Keep Trunk CID" is enabled, the CallerID configured for the trunk
will be used.

If the above two are missing, the "Global Outbound CID" defined in
web GUI->PBX->Internal Options->General will be used.
Configure the new name of the caller when the extension has no CallerID
Name configured.
UCM6510 IP PBX User Manual Page 100 of 229