Grandstream Networks UCM6510 IP PBX User Manual page 121

Strip
Dial Trunk
DID Destination
Time Condition
Start Time
End Time
Date
Week
Destination
Firmware Version 1.0.0.25
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299

By DID
When "By DID" is used, the UCM6510 will look for the destination
based on the number dialed, which could be local extensions,
conference, call queue, ring group, paging/intercom group, IVR,
voicemail groups and Fax extension as configured in "DID
destination". If the dialed number matches the DID pattern, the call
will be allowed to go through.

Dial By Name
Specify the number of digits to strip from the beginning of the DID. This is
used when "By DID" is selected in "Default Destination".
Configure to allow the inbound call to dial out from the PBX's trunk or not.
The default setting is disabled. Please be aware of potential security risk
if "Dial Trunk" is enabled. The inbound call might be able to dial out
international calls from the PBX's trunk if allowed by the privilege level.
Select the DID destination if "By DID" is selected in "Default Destination".
Only the selected category can be reached by DID using this inbound
route.

Extension

Conference

Call Queue

Ring Group

Paging/Intercom Group

IVR

Voicemail Groups

Fax Extension

Dial By Name
Select the start time "hour:minute" for the trunk to use the inbound rule.
Select the end time "hour:minute" for the trunk to use the inbound rule.
Select "By Week" or "By Day" and specify the date for the trunk to use the
inbound rule.
Select the day in the week to use the inbound rule.
Select the destination for the inbound call under the defined time
condition.

Extension

Voicemail

Conference Room

Call Queue

Ring Group
UCM6510 IP PBX User Manual Page 119 of 229