Disa; Table 47: Disa Settings; Figure 75: Create New Disa - Grandstream Networks UCM6510 IP PBX User Manual

The UCM6510 supports DISA to be used in IVR or inbound route. Before using it, create new DISA under
web GUI->Call Features->DISA.

Click on "Create New DISA" to add a new DISA.

Click on to edit the DISA configuration.

Click on to delete the DISA.
Name
Password
Permission
Firmware Version 1.0.0.25
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299

DISA

Figure 75: Create New DISA

Table 47: DISA Settings

Configure DISA name to identify the DISA.
Configure the password (digit only) required for the user to enter before
using DISA to dial out.
Note:
The password has to be at least 4 digits.
Configure the permission level for DISA. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to
the highest level. The default setting is "Internal". If the user tries to dial
outbound calls after dialing into the DISA, the UCM6510 will compared
the DISA's permission level with the outbound route's privilege level. If
the DISA's permission level is higher than (or equal to) the outbound
UCM6510 IP PBX User Manual Page 159 of 229