Dcn-Mic Microphones; Dcn-F Flush Mounted Units - Bosch DCN Next Generation Operation Manual

Conference System
9.9 DCN-WAP Wireless Access Point
Problem
Long time needed for upgrading Wireless
Access Point.
–
–
9.10

DCN-MIC Microphones

Problem
A pluggable microphone does not operate as
expected.
9.11

DCN-F Flush Mounted units

Problem
–
9.12 DCN-DDB Data Distribution Board
Problem
–
Bosch Security Systems B.V.
LEDs on the WAP are: Off / Flashing slow/
Off.
CCU shows 'incompatible SW'.
A flush-mounted device does not operate
as expected.
The data distribution board does not
operate as expected.
Hint
–
–
This is normal system behavior; it is
mentioned here to remind the user.
–
–
Hint
The pluggable microphone is defective.
Replace the pluggable microphone.
Hint
–
Hint
–
Operation Manual
Troubleshooting | en
The Download and License Tool can
be used for upgrading. When "Down
Load Optical" is selected, all
applicable devices connected to the
optical network will be upgraded. In
case the DCN-WAP is connected, it
will take more than 30 minutes to
upgrade the DCN-WAP
Bypass: In case the DCN-WAP does
not need to be upgraded, do not
connect the DCN-WAP when
selecting "Download Optical".
DCN-WAP or CCU contains old SW.
To solve this, use the Download &
License Tool to upgrade the CCU and
DCN-WAP to the same version.
The dual delegate interface of the
flush-mounted device is not in the
correct mode. Refer to DCN-DDI Dual
Delegate Interface, page 213for
instructions that tell you how to
change the mode of the dual
delegate interface.
The data distribution board is not in
the correct mode. Refer to DCN-DDB
Data Distribution Board, page 228 for
instructions that tell you how to
change the mode of the data
distribution board.
2013.11 | V2.0 | DCN-NG_OM_V4.x
267