Bosch DCN Next Generation Operation Manual page 212

212 en | Configuration
–
–
When you put the discussion unit in the dual delegate mode, you must also install the
DCN‑DISBDD Buttons.
Figure 7.16: DCN-DISBDD Buttons
Notice!
The DCN-DISBDD buttons come with a tool that you can use to remove the old buttons from
the discussion unit (refer to DCN-DIS and DCN-WD Discussion units, page 96).
Single delegate with auxiliary control
When the discussion unit is in the single delegate with auxiliary control mode, it is a delegate
device for 1 delegate. The delegate can use the left microphone button as an auxiliary button.
For example, to activate an indicator.
Notice!
When the delegate pushes the auxiliary button, the auxiliary button makes an event. Use the
Open Interface to program the actions that must be started by the event. Refer to the
applicable Software User Manual for instructions that tell you how to program the Open
Interface.
You can only put these types of discussion units in the single delegate with auxiliary control
mode:
–
–
–
–
–
–
–
–
When you put the discussion unit in the single delegate with auxiliary control mode, you must
also install two microphone buttons (refer to DCN-DIS and DCN-WD Discussion units, page 96).
For example, you can use the DCN-DISBCM Buttons.
2013.11 | V2.0 | DCN-NG_OM_V4.x
DCN-WDD
DCN-WDDCS
DCN-DISD
DCN-DISDCS
DCN-DISV
DCN-DISVCS
DCN-WDD
DCN-WDDCS
DCN-WDV
DCN-WDVCS
Operation Manual
Conference System
Bosch Security Systems B.V.