Bosch DCN Next Generation Operation Manual page 166

166 en | Connection
2.
Figure 6.77: Crimping a socket contact (2)
3.
Figure 6.78: Mounted socket contacts
Remove the sheath from the optical fibers
Proceed as follows:
1.
2013.11 | V2.0 | DCN-NG_OM_V4.x
Put one of the bare, copper wires into the contact area of the socket contact. Close the
crimping tool to crimp the socket contact onto the copper wire.
Repeat steps 11 and 12 for the other bare copper wire. Refer to the figure to see the
result of this part of the cable-connector mounting procedure.
A
Put the plastic optical fibers into the POF cutter/stripping tool (tool 6). The optical fiber
that is to be cut must be put in the small guide hole. The other optical fiber must be put
in the large guide hole. Push the cable until the crimping bush is against the stop.
B
Operation Manual
Conference System
Bosch Security Systems B.V.