Bosch DCN Next Generation Operation Manual page 33

Conference System
1.
Notice!
A DCN-MICL or DCN-MICS Pluggable Microphone cannot used with the DCN-DISL and DCN-
DISS Discussion Units. The DCN-DISL and DCN-DISS Discussion Units have fixed
microphones.
2.
3.
4.
Notice!
Change the type of language abbreviation with menu e of the installation menu of the
interpreter desk (refer to DCN-IDESK Interpreter Desks, page 221 > Menu screens).
5.
6.
7.
8.
9.
10. DCN socket - Makes a loop-through in the DCN with the discussion unit.
11. Status LEDs - Gives information about the condition of the wireless discussion unit.
12. Screw holes - Attach the wired discussion unit to a flat surface.
13. Configuration switches - Configuration of the discussion unit and sets the mode of the
14. De-init switch - Erases the address (wired) / subscription (wireless) of the discussion
15. Battery pack compartment - Contains the Battery Pack (DCN-WLION) of the wireless
16. Power supply socket - Connects a Power Supply adapter (DCN-WPS) to the wireless
The following sections give more information about the mentioned subject:
–
–
–
–
–
–
Bosch Security Systems B.V.
Microphone socket - Connects a Pluggable Microphone (DCN-MICL or DCN-MICS) to the
discussion unit.
Loudspeaker - Gives the audio signal from the floor to the delegate or the chairman. The
loudspeaker signal is muted when the microphone is enabled.
Volume buttons - Headphone signal level adjustment.
Channel selector display - Shows the number of the language channel and abbreviation
of the current headphone audio signal. When the display shows FLR, the floor audio
signal is on the headphones.
Channel selector buttons - Select the channel that is sent to the headphones.
Microphone buttons - Enable or disable the microphone. Each microphone button has a
LED that shows the condition of the microphone. The mode of the discussion unit gives
the type and number of microphone buttons which must be installed in the discussion
unit.
Voting buttons - Operate the discussion unit. Each voting button has a yellow LED. The
LED adjacent to voting button 1 is the attendance LED.
Headphones socket - Headphone connection.
DCN cable - Connects the discussion unit (wired) to the DCN.
discussion unit.
unit. All LEDs on the discussion unit are on when the discussion unit does not have an
address.
discussion unit.
discussion unit.
Installation: DCN-DIS and DCN-WD Discussion units, page 96.
Connection: DCN-DIS Discussion Unit (wired), page 128 and DCN-WD Discussion Units
(wireless), page 129.
Configuration: DCN-DIS and DCN-WD discussion units, page 208.
Operation: DCN-DIS and DCN-WD Discussion Units, page 246.
Troubleshooting: DCN-DIS Discussion Unit, page 264.
Technical Data: DCN-DIS and DCN-WD Discussion Units, page 280.
Operation Manual
System Overview | en
2013.11 | V2.0 | DCN-NG_OM_V4.x
33