Bosch DCN Next Generation Operation Manual page 171

Conference System
Figure 6.88: Crimping ferrules (3)
Figure 6.89: Ferrules on fibers
Assemble the connector
Before you start to assemble the connector, the copper wires and the plastic optical fibers for
must be correctly put in the connector. The copper wires will be attached to the upper part of
the connector, the optical fibers will be attached to the lower part of the connector (refer to
Figure 5.42).
Notice!
When replacing a connector, always first check the wiring in the connector at the other end.
Figure 6.90: Front view of connector
Refer to the wiring diagram and the figures.
Pin
E1
E2
Bosch Security Systems B.V.
A
E1 E2
O1 O2
B
Signal
+48V(DC)
GND
Operation Manual
Connection | en
Wire
Copper
Copper
2013.11 | V2.0 | DCN-NG_OM_V4.x
171