Bosch DCN Next Generation Operation Manual page 164

164 en | Connection
Figure 6.72: Crimping the bush
Remove the ends of the copper wires
Do as follows:
1.
Figure 6.73: Cutting a copper wire
2.
2013.11 | V2.0 | DCN-NG_OM_V4.x
Hold the crimping bush in position I with the stripping tool. Cut the copper wires at
position II with the cable cutter (tool 2).
I
II
Push the copper wires to the mechanical stop of the stripping tool (tool 5). Remove the
red and brown insulations from the copper wires.
Operation Manual
Conference System
Bosch Security Systems B.V.