Bosch DCN Next Generation Operation Manual page 245

Conference System
Blue (A)
Off
Off
Off
On
On
On
On
On
Table 8.20: Status LEDs
Notice!
Flashing (fast) = one second on, one second off.
Flashing (slow) = one sec on, three seconds off.
Always check the area with the WiFi finder to prevent disturbance from other networks.
8.7 DCN-CON Concentus Units
The color of the LED of the microphone button shows the condition of the microphone that is
connected to the Concentus unit.
Color
Red (on)
Red (flash)
Green (on)
Green (flash)
Yellow (on)
Table 8.21: Condition
Bosch Security Systems B.V.
Red (B) Blue (C) Description
Flashing Off The wireless mode is set to Off, or the power value of the
(slow) Wireless Access Point is set to Off. This LED sequence is
also used to indicate that the Central Control Unit is
incompatible with the Wireless Access Point (if this is the
case, a message "incompatible HW/SW" is also shown on
the display of the Central Control Unit).
Off Off No power to the Wireless Access Point.
On Off The Wireless Access Point lost connection with the
optical network. Check replace the optical cable.
Flashing Off This indication remains active until the download process
(fast) is completely finished.
Off Flashing One or more Wireless Discussion Units are connected to
(fast) the system, and menu item 3B, one of the 3B submenus,
or 4Kd of the configuration menu of the Central Control
Unit is open. Use these menu items to configure the
Wireless Access Point.
Off On The wireless mode is set to Subscription, and one or
more devices are connected to the system.
Off Off The wireless mode is On, and one or more Wireless
Discussion Units are connected to the system.
On On Internal error in Wireless Access Point. Check if: the
Software is downloaded, possible error message
displayed on the CCU. Or replace the WAP.
Condition
Microphone enabled
Last minute of speech time
Request-to-speak
First in request-to-speak list
VIP mode
Operation Manual
Operation | en 245
2013.11 | V2.0 | DCN-NG_OM_V4.x