Cobranet Discovery - Bosch DCN Next Generation Operation Manual

Conference System
Notice!
If two systems are connected by audio connections (Cobranet, AEX, or DEX), set the AGC to
off.
7.7

CobraNet Discovery

Overview
Install the CobraNet Discovery on your PC with the DVD that is supplied with your system. The
DVD contains an automatic set-up program.
With the Configuration window, you can configure CobraNet Discovery. To open the
Configuration window, go to Tools > Options.
Figure 7.6: CobraNet (tm) Discovery window
Network adapter
In the Network Adapter block, you must choose the Ethernet card of the PC that is used to
connect to the CobraNet network.
IP addresses
When you put a checkmark in the Enable Auto Assignment box in the IP Address Range block,
CobraNet Discovery automatically gives IP addresses to new CobraNet devices. You can set
the range of automatically given IP addresses with the Start and End fields.
Notice!
When you remove the checkmark from the Enable Auto Assignment box, you will get access to
the Start and End fields.
Firmware
Normally the firmware does not need updating. If you do have to update the firmware, you
must use the database location on the PC.
Start - CobraNet Discovery
Make sure that the PC, on which you installed the CobraNet Discovery, is connected to the
CobraNet network. On the PC, go to Start > Programs > CobraNet Discovery. The monitor of
the PC shows the CobraNet (tm) Discovery window.
Operation
The CobraNet (tm) Discovery window shows the CobraNet devices on the CobraNet network
and their Ethernet parameters.
Bosch Security Systems B.V. Operation Manual
Configuration | en 199
2013.11 | V2.0 | DCN-NG_OM_V4.x